FirstSurge Power 60 kA Surge Protector Bundle by Siemens

Knowing when a surge protector needs to be replaced is the Key to remaining protected. This is why we developed our FirstSurge Total power, cable and telephone surge protector kit. Installed at your load center, FirstSurge will stop surges before they get into your home. The key to remaining surge protected is knowing when a surge protector needs to be replaced. When FirstSurge wears out, its commercial class 3-stage notification diagnostics immediately alerts you that it needs replacing. This type of notification results in a far shorter Mean Time Before Surge Protection Restoration (MTBSPR) when compared to standard whole house protectors equipped only with LED diagnostics. Knowing your surge protected with commercial class protection gives you peace of mind that your smart appliances and electronics will always be surge protected. When installed at your cable TV service, our FirstSurge Cable Surge Protector (FSCATV) will stop surges before entering cable signal distribution splitters or patch panels. Every FSCATV is sized with enough surge current capacity allowing it to take multiple surge hits without wearing out. When installed at your telephone service, our FirstSurge Telephone Surge Protector (FSPHONE) protects against electrical power surges that can enter through the main telephone connection and is equipped with a fail short device to permanently ground the telephone line in the event of a power cross.

• FirstSurge stops electrical AC surges at your load center or breaker box before it can reach your smart appliances and electronics
• FirstSurge power provides 60,000 Amp of surge current capacity
• FirstSurges balanced 600-Volt voltage protection ratings means every primary paired conductor (line to neutral, line to ground and neutral to ground) will knock down surge overvoltage’s to safe levels
• Every FirstSurge electrical AC service protector is equipped with worry free commercial class 3-stage notification; when FirstSurge wears out, its audible alarm will beep, protection status LED’s extinguish and red service LED flashes
• When 3-stage notification activates, you turn off FirstSurges dedicated breaker and you contact your electrician to arrange for installation of replacement unit
• FirstSurge can be used to surge protect any load center brand when connected to a 30 Amp or less 2-pole circuit breaker
• FirstSurge FSCATV stops cable TV surges at your incoming CATV service before it can reach your sensitive electronics and high speed Internet modems
• FSCATV includes a section of coaxial cable with female to female splice for line side application
• FirstSurge FSPHONE stops telephone surges at your incoming telephone service before it can reach your home phones